VENERE Car Lift

Home
Solutions
Car Lifts
VENERE Car Lift

The Venere model car lift, makes it possible to overcome even considerable height differences; it can also be arranged for intermediate floor stops.

The car-lifting system consists of two supporting columns (anchored, with appropriate connections, to the wall adjacent to the long side of the system) and hydraulic cylinders for up and down movement. All supporting structures are made of hot-dip galvanized S 275JR steel, while the floors are made of anti-skid almond plate.

The car hoist is arranged to connect gates and/or safeties placed both on the different levels and on the platform of the hoist. In addition, it is possible to install tightly woven mesh perimeter guards (it is guaranteed that it is impossible to intrude any part of the human body – height.200 cm) on some sides of both the lift and the technical compartment.

The car hoist can be supplied in the “MAN ON BOARD” version with CE certification issued by Primary Certifying Body.

VENERE CAR LIFT SAFETY DEVICES

The plant is tested according to current regulations (Machinery Directive). The operation of the car lift is done exclusively by operating the button after inserting the key (“man-present and responsible” handling).

The control device is installed outside the range of the car lift system. Parachute block valves and pressure relief valves on hydraulic cylinders are provided.

The switchboard can be arranged for the connection of electric floor latches and/or safeties in order to make the handling of the car lift more protected. Power indicator lights are provided on the push button panel, and flashing floor lights are installed to signal the movement of the car lift.

Electrical installations made according to IEC 64-2. Control panel set up for “man-present and responsible” movement, activated by low voltage (24 volts), controlled by key switch with red light and emergency stop. General management framework of electrical components. Electric motor, applied on hydraulic unit, powered by three-phase current 380 volts (5.5 HP – 4 Kw). Adjustable electric limit switches at the floor. All electrical equipment has a degree of protection of not less than IP55.

TECHNICAL FEATURES

TECHNICAL FEATURES VENERE CAR LIFT
Compartment size:	540 x 260 cm.
Platform size:	534 x 250 cm.
Technical pit depth:	100 cm.
Useful stroke (between finite planes):	900 cm. (higher height differences on request)
Useful scope parking space:	3,000 kg.
Load-bearing structures and sheet metal:	Steel
Average speed:	5 cm/sec.
Motor:	7.5 Kw
Electric current:	Three-phase Volts 380
Hydraulic power unit:	40×60 H 100 cm. (inserted into adjacent compartment)
Electrical panel:	20×40 H 50 cm. (arranged for safeties and latches)
Floor pushers:	10×10 H 20 cm. (with removable key and emergency button)
Security:	Emergency STOP button
Plant handling:	With removable key and “man-present and responsible handling”
End of plan run:	Electric adjustable floor level
Plant in motion:	Flashing floor warning light
Full warranty:	2 years

OPTIONS ON SUPPLY

VENERE CAR MOUNT SUPPLY OPTIONS
Platform size:	Customizable according to different needs.
Closures and safeguards:	Automatic floor gates REI Doors Infrared anti – intrusion barriers Car centering photocells on the flatbed Synoptic outline outline car Anti-shear perimeter hose
Push-button panel with flashing light:	Additional for each loading/unloading floor
Uninterruptible power supply:	On demand in case of power failure